Very practical multi-purpose 19” rack case with up to 18U rack space on the front. Up to 10U extra rack space on top to install 19” mixers, controllers, etc Sliding Laptop support on top with transport straps (can be removed to increase the height of the installed mixer to 12U) Keep your equipment wired in the case so you can set up your gear in seconds ! Strong 9mm plywood construction Equipped with: 4 Rotating castors of good quality (2 with brake) 4 Recessed flip handles 8 Butterfly catches The details make the difference: Front cover: can be transformed in seconds into a table the table can be used on the right side or the left side of the case. A cable passage is provided on both sides of the case Laptop support: Thanks to its design, the portable computer can stay inside of the case during transport The Velcro straps fixed on the tray + the extra foam in the top cover will help to keep your laptop in place during transport The rails of the laptop support tray are mounted low enough so they are not disturbing you when you use a 19” mixer or controller in the horizontal rack space. If you don’t need this laptop support, you can simply take it off Rear door: Faster to open / close as a normal rack cover Corner cutout so the door can be closed, even when cables come out of the case.